Here is a 1x12 Empty Guitar Cabinet constructed of 1/2 inch baltic birch plywood. It has a 3/4 inch baltic birch plywood baffle. The cabinet has some slight minor imperfections but is 100 percent functional and has been tested and sounds great. It will come with a 1/4 inch Baltic Birch front cover with magnets to protect the speaker during transport (not photographed yet). It will come with standard speaker clips to hook up most speakers, but you can just clip them off if you are using JBL's. It weighs 14 lbs 12 oz with the front cover. It has two jacks wired in parallel. You can use either one, they will both work. Additionally, you can run a line out to another cabinet if necessary. If you have an 8 ohm speaker in the cabinet and run a line out to another cabinet with an 8 ohm load, you will have 4 ohms total. It is finished with boiled linseed oil, it has a metal handle on top for carrying and draping a mic. It has knotty alder trim with magnets, rabbet and dado joints, bolts with locking nuts on the handle and input jack plates and sturdy rubber feet. It is 15x15x13. If you are using a speaker other than a JBL, some small wooden shims may be required to mount the speaker. Just the empty cabinet (including all the hardware, ht style clips, magnets, etc...) and front cover are included in the sale. You can finish it further with a hard polyurethane or something similar, although it is fully finished with the boiled linseed oil now. A hard finish would protect better from scratches and dings, but is not necessary.