RM&S is a 4HP
Ring Modulator and Sub-Octave generator.
The Ring Modulator is an active, CMOS-based circuit adapted from the ARP Odyssey. Ring Mod is usually generated from inserting
square wave VCOs to Input 1 & 2. But
that shouldn't stop you from sending sawtooth, wavetables and noise sources
through this.
The Sub-Octave Generator
circuit is derived from the Roland SH-101
and provides -1 and -2 octaves from a square wave plugged into Input 1. Many VCOs put out varying degrees of signal
amplitude, a trim pot is provided to adjust input impedance of VCOs for the
Sub-Octave Generator circuit.
Output
jacks include: Ring Mod, summed Ring Mod + Sub-1, Sub-1, and Sub-2. The RM&S
is hand-crafted in the USA.
Measured Current Draw: 2mA on -12V, 5mA on +12V, 5V not used
Be sure to check out my other Eurorack modules in my Reverb store.